RevIntegrator for Imaging - Step 3 of 5: Settings Configuration

Settings need to be completed before using RevIntegrator for Imaging.

Instructions

1. Launch RevIntegrator for Imaging. Note: Use the desktop icon or launch from the Start Menu.
2. Click 'Edit.'
3. Access Settings > Device Interfaces tab. 
4. Click the 'Details' button within RevIntegrator.
5. From the Service Type dropdown menu, select Device.
6. From the Environment Type dropdown menu, select production.
7. Complete the credentials information obtained from the RevIntegrator for Imaging - Setup instructions to include Username, Password, and Location ID.
8. Confirm "Is Selected" is checked.
9. Click 'Test Connection.' A success message displays. 
10. Click 'Save and Close.'
11. Click the 'Details' button within RevIntegrator for Imaging.
12. From the Service Type dropdown menu, select Bridge.
13. From the Environment Type dropdown menu, select Production.
14. Complete the credentials information obtained from within the RevIntegrator for Imaging - Setup instructions to include Username, Password, and Location ID.
15. Confirm "Is Selected" is checked.
16. Click 'Test Connection.' A success message displays. 
17. Click 'Save and Close.'
18. Proceed to File Upload - Profile Configuration.

Next Steps

 Continue setting up RevIntegrator for Imaging using the articles below:

1. RevIntegrator for Imaging - Step 1 of 5: Download and PC Requirements
2. RevIntegrator for Imaging - Step 2 of 5: Enable RevIntegrator for Imaging
3. This article is the third step in the process. 
4. RevIntegrator for Imaging - Step 4 of 5: Configure Your Device to Export to a Folder On Your PC
5. RevIntegrator for Imaging - Step 5 of 5: Configuring the Imaging Device's Profile