RevIntegrator for Imaging - Setup

RevolutionEHR contains information that is required to configure the setup of Revintegrator for Imaging.

Instructions

1. Access Admin > General > Practice Preferences > Partner Integrations > Device Interfaces.
2. If RevIntegrator has not been enabled, highlight the line-item, and click 'Enable.'
3. Make a note of the User Name and Password. These credentials are needed in the Configuration > Settings step. We recommend opening a document to copy and paste the credentials to be used later. This will ensure accuracy of data entry. 
4. If RevIntegrator for Imaging has not been enabled, highlight the line-item, and click 'Enable.'
5. Make a note of the User Name and Password. These credentials are needed in the Configuration > Settings step. We recommend opening a document to copy and paste the credentials to be used later. This will ensure accuracy of data entry. 
6. Access Administration > General > Locations. Within the Location Listing, make a note of the location number assigned to your location. 
7. The information that has been retrieved in the steps above is necessary to complete during the configuration process within Settings. 
8. Proceed to Managing File Storage. 

Additional Information

We recommend reviewing the following articles:

1. RevIntegrator for Imaging
2. This article, Setup, is the second step in the process. 
3. RevIntegrator for Imaging - Managing File Storage
4. RevIntegrator for Imaging - Settings
5. RevIntegrator for Imaging - Profile Configuration